Steering Wheel
Steering WheelBrass typeBrass was a bit tricky to work with because of the amount of heat required to fuse the solder joint. In the end I went to a workshop and they used a gas torch to do that. Later, however, the joint separated. So I used a wood version after that.
But that was too hard!
Wooden VersionI used a 6cm diameter hole saw to cut the outer steering wheel component.
Wooden VersionI used a 6cm diameter hole saw to cut the outer steering wheel component.
SandingThen bolted into a drill press for sanding.
Cutting the inner component with a 4mm diameter hole saw. Outer is screwed down to the base.
Glue each arm at a 120 degree angle
Glue each arm at a 120 degree angle
Steering wheel attached to the bulkhead with an angle bracket on the instrument panel (adjusted to fit)
